• Pipe Connection Valve

    Exceeds industry standard of 15,000 psi. Pipe valves with metal to metal seats have a high level of safety and reliability under adverse operating conditions. These valves may be used both with gases and liquids. Traceability is ensured through extensively documented data (batch number, maximum pressure, material number, type designation). All pipe valves come with female national pipe threads (FNPT). These are high pressure NPT fittings for pressures up to 15,200 psi.

  • Pipe Fittings Pressure to 15,200 psi

    Exceeds industry standard of 15,000 psi. MAXIMATOR Pipe fittings are designed for liquid and gas applications. The P Series Fittings are available from 1/4" to 1" NPT to 15,200 psi.  These are high pressure NPT fittings for pressures up to 15,200 psi.

    NPT threads must be sealed using a high quality PTFE tape and/or paste product. Sealing performance may vary based on many factors such as pressure, temperature, media, thread quality, thread material, proper thread engagement and proper use of thread sealant.

    MAXIMATOR Recommends to limit the number of times an NPT fitting is assembled and disassembled because thread deformation during assembly will result in deteriorating seal quality over time. When using only PTFE tape, using thread lubrication to prevent galling of mating parts is recommended.

  • Pipe Hex Nipples Pressure to 15,200 psi

    MAXIMATOR Pipe Hex Nipples are designed for rapid system make-up. They are available in various lengths for pipe valves and fittings. The connection type for these nipples are high pressure NPT for pressures up to 15,200 psi.

    In addition to the minimum lengths (Pipe Hex Close Nipples) and standard lengths listed in the table below, Pipe Hex Nipples are also available in custom lengths. Please consult factory.

  • Pipe Hex Nipples Pressure to 15,200 psi

    MAXIMATOR Pipe Hex Nipples are designed for rapid system make-up. They are available in various lengths for pipe valves and fittings.

    These Pipe Hex Close nipples are high pressure NPT nipples for pressures up to 15,200 psi.

    In addition to the minimum lengths (Pipe Hex Close Nipples) and standard lengths listed in the table below, Pipe Hex Nipples are also available in custom lengths. Please consult factory.

  • Pipe Check Valves Pressure to 15,200 psi

    Pipe o-ring check valves provide high quality directional flow control and bubble tight shutoff for liquids and gases. These check valves are not to be used as a relief device. The opening pressure of the o-ring check valves is approximately 10 psi.

    Pipe ball check valves prevent reverse flow where bubble tight shutoff is not mandatory. These check valves are designed to operate to 660°F. These check valves are not to be used as a relief device. The opening pressure of the pipe ball check valves is approximately 10 psi.

    Connection type on these is high pressure NPT fittings and connections.

  • Pipe Line Filters Pressure to 15,200 psi

    MAXIMATOR Pipe line filters are used to filter process fluids in high pressure systems. The cup type design is used when maximum filtration surface area and a single micron size element is preferred. These high pressure NPT fittings are rated to 15,200 psi.

    This design increases the filter area as much as 6 times the area of the disc type filter, and will permit higher flow rates with a lower pressure drop, and longer intervals between element changes. Filter elements come standard in: 5, 30 or 56 micron sizes and are easily replaced. Filters are rated for temperatures -60°F to 660°F.

    Materials:
    Body, cover, cover gland: 316 series stainless steel
    Element: 300 series stainless steel

© 2017 MaxPro Technologies Inc, All Rights Reserved Site created by Thomas Web Solutions and powered by Navigator Platform